{{ post.title }}
글 편집
{{ post.author.name }}
Posted on
| Version | {{ post.target_version }} | Product |
{{ product.name }}
|
|---|---|---|---|
| Tutorial/Manual | {{ post.manual_title }} | Attached File | {{ post.file.upload_filename }} |
You can perform a load transfer in MBD for ANSYS and specify the Set FE Boundary Condition in the ANSYS Structure to fetch the loads.
To do so, you must specify the surface that generates each load.
If there are too many loads or if the geometry is complex, then you can specify the Set FE Boundary Condition to generate the coordinate system and locate the surface using the coordinate system.
The object of the coordinate system uses the same name as the object used for the load transfer.
